Description
HUM Audio Devices ARM-1L is Phantom powered active ribbon microphone equipped with 2″ long, 1.8u thick ribbon element. Output signal level is higher comparing to passive ribbon mics because of fully discrete active stage.High-end class electronic components and manufacturing techniques allowed us to achieve very low noise floor and detailed rich sound.It’s also equipped with switchable low cut filter (50/100 Hz)
Features
PHANTOM POWERED ACTIVE RIBBON MIC
DETAILED RICH SOUND
2″ LONG, 1.8U THICK RIBBON ELEMENT
VERY LOW SELF-NOISE
SWITCHABLE
LOW CUT FILTER
FULLY DISCRETE DESIGN
RIBBON ELEMENT: 2" LONG (1,8U ALUMINUM FOIL)
POLAR PATTERN: FIGURE-8
SUPPLY: PHANTOM +48V (+/- 5V)
FREQUENCY RESPONSE: 30Hz - 14KHz (+/-3DB)
SENSITIVITY: -38DB (1V/PA)
MAX. SPL: 137DB
OUTPUT IMPEDANCE: 22 OHM (ELECTRONIC)
RECOMMENDED LOAD IMPEDANCE: 150 OHM OR GREATER
HPF: 50Hz/100Hz (6db/oct)
Components
ARM-1L Microphone
Mic head dust protection cover
Flight case
Description
HUM Audio Devices ARM-1S is Phantom powered active ribbon microphone equipped with 1″ long, 1.8u thick ribbon element.Output signal level is higher comparing to passive ribbon mics because of fully discrete active stage.High-end class electronic components and manufacturing techniques allowed us to achieve very low noise floor and detailed rich sound.It’s also equipped with switchable low cut filter (50/100 Hz)
Features
PHANTOM POWERED ACTIVE RIBBON MIC
DETAILED RICH SOUND
1″ LONG, 1.8U THICK RIBBON ELEMENT
VERY LOW SELF-NOISE
SWITCHABLE
LOW CUT FILTER
FULLY DISCRETE DESIGN
RIBBON ELEMENT: 1" LONG (1,8U ALUMINUM FOIL)
POLAR PATTERN: FIGURE-8
SUPPLY: PHANTOM +48V (+/- 5V)
FREQUENCY RESPONSE: 40HZ - 14KHZ (+/-3DB)
SENSITIVITY: -39DB (1V/PA)
MAX. SPL: 138DB
OUTPUT IMPEDANCE: 22 OHM (ELECTRONIC)
RECOMMENDED LOAD IMPEDANCE: 150 OHM OR GREATER
HPF: 50HZ/100HZ (6DB/OCT)
Components
ARM-1S Microphone
Mic head dust protection cover
Flight case
LAALLOOK AHEAD ANALOG LIMITERThe LAAL mastering limiter is absolutely exceptional in many ways. An innovative idea of detection and limiting process allowed it to achieve a new standard in analog mastering.
One of the strongest advantage of its design is fully analog (0.2 ms) delay line to obtain “Look Ahead” ability. Thanks to it the detection circuit can react to even the fastest peaks.
LAAL is extremely effective in this task, allowing you to reach great RMS levels when required, but with minimal side effects and without compromising sound quality.
Your track will also preserve low-end energy and punch in wide gain attenuation range.FeaturesAll discrete audio signal pathVery high headroom (+/-24V INT. Powering)Highest quality audio transformersUltra stable linear power supplyThermal compensation for ultra precise detection circuitAnalog look ahead circuit (0,2 ms analog delay line)Variable stereo width functionDynamic transient functionVariable release time (stepped, 2 ms to 100 ms)Precise LED metering (0,2 dB steps)Precise Input/Output setting (0,2 dB steps)Peak hold function for gain reduction metersRotary step switches for all knobsStereo link for detectionCustom made shielded ac cordLimiter bypassHard bypassHandcrafted in Poland
HUM Audio Devices RP-2 is transformer balanced, fully discrete Class-A design equipped with remote controller. The connection between preamp box and controller requires only one standard XLR cable so it’s very convenient in use. Gain circuit uses photo cells to control the levels so there is full separation between audio path and remote signal.RP-2 preamp offers massive, dynamic sound with lots of sonic details.It’s great for all types of mics, especially ribbons because of very low self-noise.
Features
FULLY DISCRETE CLASS-A DUAL-CHANNEL MIC PREAMP
VERY LOW SELF-NOISE
REMOTE-CONTROLLED VIA STANDARD XLR CABLE
AIR BOOST PULTEC STYLE HIGH FREQUENCY BOOSTER
TRANSFORMER BALANCED
ADDITIONAL HIGH IMPEDANCE INSTRUMENT/LINE TRS INPUTS
TRANSFORMER BASED
M/S DECODER
ANTI-THUMP PHANTOM POWER SWITCHING SYSTEM
THD+N: 0,027% AT 60DB GAIN
PHANTOM POWER +48V
PAD -20DB
M/S MATRIX Passive transformer based M/S to Stereo decoder
LOW CUT FILTER 50HZ (6DB/OCT)
AC MAINS POWER INTERNALLY SWITCHABLE 240V/120V (50HZ - 60HZ)
FREQUENCY RESPONCE: 20HZ - 50KHZ (+/-0,4DB)
ADDITIONAL HIGH IMPEDANCE INSTRUMENT/LINE TRS INPUTS
AIR BOOST Passive Pultec Style shelf high frequency booster
GAIN RANGE 20DB - 60DB
PHASE INVERSION
CUSTOM MADE CABLES
Components
RP-2 Preamps
RP-2 Remote Control Unit
RP-2 Power Supply Unit
Custom made cables (remote, psu, mains)
Mic head dust protection cover
Flight case
Description
HUM Audio Devices RS-2 is extraordinary, complete recording system with sound and features never before found in any of the topclass ribbon mics. Huge, larger than life sound with a lot of depth and details, at the same time preserves classic ribbon sound flavour so much beloved by musicians and engineers.
Features
Active and Passive mode
High End, discrete class-A ink preamps built into mic body
Custom made 1,8 micron aluminium foil ribbon motors
Remote control system gives access to all functions via single XLR cable
Switchable Low Cut Filter (50Hz, 80Hz and 120Hz)
Air Boost mode gives you very smooth Pultec style HF boost
Transformer based M/S matrix
Phase Invert mode for both mic channels simultaneously
Very useful DIMM option protects speakers during mic positioning
Rotable mic head for fast change between L/R to M/S position
High gain and huge headroom no worry about high source SPL
Dual anti-vibration system (external and internal)
Custom made signal and power cables
Lundahl mic and line output transformers
Extremely short signal patch
Audiophile quality selected components
No electrolytic capacitors in signal patch
RS-2 Stereo Ribbon Recording System components:
RS-2 Stereo/M-SMicrophone
RS-2 Remote Control Unit
RS-2 Rover Supply Unit
Custom made cables (remote, psu, mains)
Mic headdust protection cover
Flight case
€7,300.00*
Diese Website verwendet Cookies, um eine bestmögliche Erfahrung bieten zu können. Mehr Informationen ...